Batteries; Battery Pack - SAB Goblin 700 Manual

Chapter 14, Battery
BAG 19

BATTERIES

The battery tray system in the Goblin 700 is simple, but very effective.
The battery should be attached to the tray (Part H0149) with heat shrink, tape or velcro.
You can optionally use the battery protection tray (Part H0151) see Fig. 1, 2.
Before permanently mounting the batteries onto the battery tray, check the ideal position
for the best center of gravity.
Cut the heat shrink around the carbon fiber tray locking pins. Fig. 3.

Battery Pack:

Slide the tray until it locks into the CNC stopper. Fig. 4, 5.
Using the velcro straps, making sure that the two locking pins are stopped against the frame spacer
(Part1#H0003 and #H0151) Fig.6, 7.
Battery Plate
(H0149-S)
Page 28
Flat Head Cap
Screw M2.5x5mm
(HC128-S)
Cylinder M2.5
(H0151-S)
Note: Using sandpaper, sand
the slot where you insert the
battery strap. This helps
increase the life of the strap.