Table of Contents
Advertisement
Chapter 5, Transmission Assembly
BAG 4, FOAM 2, FOAM 3
Note 1:
When you tighten the collar (H0121-S) on the main
shaft, ensure there is no axial play.
Push down the main shaft while pulling up the
locking collar. Tighten the screw M4x22 at this time.
Note 2:
The pinion and gear are designed to have zero
backlash. This leads to initial "rough" rotation.
After some run in flights (3-5 flights) it will begin to
rotate freely, ensuring perfect contact and the
ability to transmit maximum power.
It is very important to lubricate these two
elements with a lubricant
( Dry Fluids Gear or similar).
Socket Head Cap
Screw Shouldered
M3x18mm
(HC079-S)
Note 2
Socket Head Cap Screw
Shouldered M4x24mm
(HC111-S)
Secondary Shaft
(H0157-S)
Note: Correct insertion of
the one-way pulley
Page 10
Metric Hex
Nylon Nut M3
(HC206-S)
19T Drive Pinion
(H0156-S)
Main Gear
(H0405-S)
Socket Head Cap
Screw M4x22mm
(HC104-S)
Socket Head Cap Screw
Shouldered M2.5x19mm
(HC033-S)
Main Shaft
(H0122-S)
Metric Hex
Nylon Nut M4
(HC212-S)
Metric Hex
Nylon Nut M4
(HC212-S)
M4 Locking Collar
(H0121-S)
60T Pulley Assembly
(H0171-S)
Bearing
10x
(HC420-S)
One Way Bearing
10x
(HC442-S)
One Way Bearing
10x
(HC442-S)
Bearing
10x
(HC420-S)
Front Tail Pulley Assembly
(H0172-S)
Socket Head Cap
Screw M2x12mm
(HC014-S)
37T Pulley
(H0172-S)
Main Structure
Assembly 1
Bush One Way
(H0110-S)
60T Pulley Assembly
(H0171-S)
Metric Hex Nylon
Nut M2.5
(HC200-S)
Washer
10x
(HC232-S)
The perfect play is 0.5mm
add or remove shim for this
15x4mm
14x12mm
60T Pulley
(H0171-S)
14x12mm
15x4mm
16x0.2mm
Advertisement
Table of Contents
