SAB Goblin 700 Manual page 27

Socket Head Cap
Screw M2.5x12mm
(HC026-S)
Servo Spacer
(H0075-S)
The tail servo wire lead must not be allowed to move
above this line (figure 1). To ensure this, it is necessary to
position it and then secure with hot glue in the area
indicated by the arrow. Figure 2 shows the installed servo.
Note: Please note that the boom edges might be
rough and can eventually chafe or cut your tail servo
lead - we recommend protecting the leads with heat
shrink or even electrical tape.
The distance between
the axis and the ball must
be between 15-16 mm
Carbon Rod Assembly
(HC239-S)
Chapter 12, Tail Servo Installation
Tail Servo Assembly
15-16mm
Socket Head Cap
Screw M2x6mm
(HC004-S)
BAG 15
Uniball M2 5H6
(H0064-S)
Tail Servo
Page 25