Onkyo TX-NR5010 Instruction Manual page 112

■
"Monitor Out" set to "Analog"
Video input signals flow through the AV receiver as
shown, with composite video and PC IN (Analog RGB)
sources being upconverted for the component video output.
Use this setting if you connect the AV receiver's
COMPONENT VIDEO MONITOR OUT to your TV.
The composite video and component video outputs pass
through their respective input signals as they are.
This signal flow also applies when the "Resolution"
setting is set to "Through" (➔ page 63).
Video Signal Flow Chart
Blu-ray Disc/DVD player, etc.
Composite PC IN Component
(Analog RGB)
IN
AV receiver
MONITOR OUT
Composite Component
TV, projector, etc
*1 For details, refer to "Video Resolution Chart"
➔ page 114
( ).
Video Signal Flow and the Resolution Setting
When the "Monitor Out" setting is set to "Analog"
(➔ page 63), if the "Resolution" setting is set to anything
other than "Through"
will be as shown here, with composite video and PC IN
(Analog RGB) sources being upconverted for the
component video output.
The composite video and component video outputs pass
through their respective analog input signals as they are.
HDMI input signals are not output.
Composite
HDMI
AV receiver
Composite
HDMI
* 1
(➔ page 63), the video signal flow
Video Signal Flow Chart
Blu-ray Disc/DVD player, etc.
Component HDMI
PC IN
(Analog RGB)
IN IN
MONITOR OUT MONITOR OUT
Component HDMI
TV, projector, etc
En-112
■
Signal Selection
If signals are present at more than one input, the inputs will
be selected automatically in the following order of priority:
HDMI, component video, composite video.
However, for component video only, regardless of whether
a component video signal is actually present, if a
component video input is assigned to the input selector,
that component video input will be selected. And if no
component video input is assigned to the input selector,
this will be interpreted as no component video signal being
present.
In the Signal Selection Example shown below, video
signals are present at both the HDMI and composite video
inputs. However, the HDMI signal is automatically
selected as the source and the video is output by the HDMI
output.
Signal Selection Example
Blu-ray Disc/DVD player, etc.
Composite Component
IN
AV receiver
MONITOR OUT
Composite Component
TV, projector, etc.
Appendix
HDMI
HDMI