Table of Contents
Advertisement
5-3. Example Displays
.
The Stick mode provides the Adaptive Hot Start feature, which automatically increases the output amperage at the start of a weld should the
start require it. This eliminates electrode sticking at arc start.
.
Values shown are hypothetical.
The "A" (Amperage) and "Trim" lights illuminate as shown.
Amperage preset display for Stick welding mode.
Voltage preset display for MIG welding mode.
Display while welding.
Preset trim display for Pulse welding mode.
Preset pulses per second (PPS) display for Manual Pulse welding mode.
OM-188 304 Page 21
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the 230Volt and is the answer not in the manual?
Questions and answers
MILL;ER WELDING MACHINE,, INVERSION AC ,354MP, SERIAL NO. LA278806 HAS NO OUTPUT,,, WIRED FOR 240 VOLT ,THREE PHASE SUPPLY,, WIRE FEED FEEDS WIRE , MACHINE SHOWS 19 VOLTS,,, THE TWO CIRCUIT BREAKERS IN BACK OF MACHINE ARE OUT,PUTTING PROPER VOLTAGES, GROUND CABLE CHECKS OK. POSSIBLE CAUSE OF PROBLEM AND ALSO A TROUBLESHOOTING GUIDE PLUS WIRING SCHEMATIC NEEDED
SEE ABOVE MESSAGE BY THOMAS EASTERDAY
Possible causes of no weld output in a Miller Electric welding machine include:
1. Line disconnect switch is Off.
2. Blown line fuse(s) or tripped circuit breaker.
3. Improper input power connections.
4. Input voltage outside acceptable range.
5. Faulty or disconnected remote control.
6. Unit overheated—requires cooling.
7. Excessive ground current detected (if equipped with ground current sensor).
You can find the troubleshooting guide and wiring schematic in Sections 4-5, 4-6, and 4-7 of the manual.
This answer is automatically generated