D-Link DCS-5220 User Manual page 39

Section 3 - Configuration
Access name for
The default name is video2.mjpg.
stream2:
Access name for stream 1 / Access name for stream 2 : The access name is used to differentiate the streaming
source. When using Mozilla Firefox or Netscape to access the Network Camera, and the video mode is set to JPEG,
users will receive continuous JPEG pictures. This technology, known as "server push", allows the Network Camera to
feed live pictures to Mozilla Firefox and Netscape. Use the following command to obtain the JPEG file:
http://<ip address>:<http port>/<access name for stream1 or stream2>
For example, when the access name for stream 1 is set to video.mjpg:
The URL command is http://192.168.0.051:80/video.mjpg
1. Launch Mozilla Firefox or Netscape
2. Type the URL command in the address field. Press Enter.
3. The JPEG image will be displayed in your web browser.
FTP Port:
Default port is 21. If you want to change the port number, you will need to specify the port when connecting to the FTP
server. For example, FTP://68.5.1.81:60 (if you use port 60 for your FTP server)
RTSP Streaming:
This setting enables you to connect to a camera by using streaming mobile device(s), such as a mobile phone or PDA.
Authentication:
Select either Basic where the password is not encrypted, or Digest where the password is encrypted during the transmission
to the web server. After you have enabled the Authentication, you will need to configure and use the access name to
access your video file. RTSP://camera ip/live.sdp (live.sdp is the default access name, you can modify in the section
below)
Access name for The default name is live.sdp.
stream1:
Access name for
The default name is live2.sdp.
stream2:
D-Link DCS-5220 User Manual 39