D-Link DCS-5220 User Manual page 38

Section 3 - Configuration
Enable UPnP Port Enables the camera to automatically add the port forwarding entry into the router.
Forwarding:
PPPoE Settings: Enable this setting if your ISP (DSL service) is using PPPoE. You may already have both Username and Password given
by your ISP, or you may check with your ISP. The Connect Status will be determined automatically by the system.
HTTP: You may configure two HTTP ports for your camera. HTTP ports allow you to connect to the camera via a standard
web browser. These ports can be set to a number other than the default TCP ports 80 and 8080. A corresponding
port must be opened on the router. For example, if the port is changed to 1010, users must type in the web browser
"http://192.168.0.100:1010" instead of "http://192.168.0.100".
Choose either Basic where the password is not encrypted, or Digest where the password is encrypted during the
Authentication:
transmission to the web server.
Note: Restart your browser, if you select Digest mode.
Basic authentication:
Digest authentication: User credentials are encrypted in MD5 algorithm and thus provide better protection against
unauthorized accesses.
The default value is 80.
HTTP Port:
The default value is 8080.
Secondary HTTP
After you have enabled the Authentication, you will need to configure and use the access name to access your video file.
Port:
For example, http://camera ip/video.mjpg (video.mjpg is the Access name, you can modify it here)
Access name for
The default name is video.mjpg.
stream1:
D-Link DCS-5220 User Manual
The password is sent in plain text format; there can be potential risks of being intercepted.
38