Table of Contents
Advertisement
2.4.2
Memory configurations
You may install 256 MB, 512 MB, 1 GB, and 2 GB ECC and non-ECC, unbuffered
DDR2 DIMMs into the DIMM sockets.
•
You may install varying memory sizes in Channel A and Channel B. The
system maps the total size of the lower-sized channel for the dual-channel
configuration. Any excess memory from the higher-sized channel is then
mapped for single-channel operation.
•
Always install DIMMs with the same CAS latency. For optimum
compatibility, it is recommended that you obtain memory modules from the
same vendor.
•
If you install four 1GB memory modules, the system may only recognize
less than 3GB of total memory because of address space allocation for
other critical functions. This limitation appears on Windows
Windows
Address Extension (PAE) mode.
•
If you install Windows
a total memory of less than 3GB is recommended.
•
This motherboard does not support memory modules made up of 128 Mb
chips or double sided x16 memory modules.
•
Due to chipset limitation, this motherboard can only support up to
8 GB on the operating systems listed below. You may install a maximum of
2 GB DIMMs on each slot.
•
Some old-version DDR2-800 DIMMs may not match Intel
On-Die-Termination (ODT) requirement and will automatically downgrade
to run at DDR2-667. If this happens, contact your memory vendor to check
the ODT value.
•
Due to chipset limitation, DDR2-800 with CL=4 will be downgraded to run
at DDR2-667 by default setting. If you want to operate with lower latency,
adjust the memory timing manually.
ASUS TW300-E5/PI4
XP 32-bit operation systems since it does not support Physical
®
Vista 32-bit / Windows
®
64-bit
Windows
XP Professional x64 Edition
®
Windows
Vista x64 Edition
®
Vista 32-bit /
®
XP 32-bit operation system,
®
's
®
2-11
Advertisement
Table of Contents
