Table of Contents
Advertisement
4.5.2
Chipset
The Chipset menu allows you to change the advanced chipset settings. Select an
item then press <Enter> to display the sub-menu.
Advanced Chipset Settings
WARMING: Setting wrong values in below sections
may cause system to malfunction.
North Bridge Configuration
North Bridge Configuration
North Bridge Chipset Configuration
Memory Remap Feature
Initiate Graphic Adapter
PEG Port Control
PEG Port Force x1
Memory Remap Feature [Enabled]
Allows you to enabled or disable the remapping of the overlapped PCI
memory above the total physical memory. Enable this option only when you
install 64-bit operating system. Configuration options: [Disabled] [Enabled]
Initiate Graphic Adapter [PEG/PCI]
Allows you to decide which graphics controller to use as the primary boot
device. Configuration options: [PCI/PEG] [PEG/PCI]
PEG Port Control [Auto]
Configuration options: [Auto] [Disabled]
PEG Force x1 [Disabled]
This item appears when the PEG Port Control item is set to [Auto].
Configuration options: [Enabled] [Disabled]
ASUS TW300-E5/PI4
BIOS SETUP UTILITY
Advanced
BIOS SETUP UTILITY
Advanced
[Enabled]
[PEG/PCI]
[Auto]
[Disabled]
Configure North Bridge
features.
ENABLE: Allow
remapping of
overlapped PCI memory
above the total
physical memory.
DISABLE: Do not allow
remapping of memory.
4-27
Advertisement
Table of Contents
