Table of Contents
Advertisement
To install the front I/O board:
1.
Place the I/O board in the bracket,
component side up. Secure the
front I/O board to the bracket with a
screw.
2.
Position the I/O board into the bay
with the component side to the left
(close to the HDDs). Connect the
I/O cables to the connectors on the
back of the I/O board.
3.
Insert the I/O board into the bay
until the bracket fits the front edge
of the bay.
4.
Secure the I/O board bracket with
a screw.
2-40
USB 2.0 connector
Chapter 2: Hardware setup
Advertisement
Table of Contents
