Table of Contents
Advertisement
2.7.2
Installing an HDD dummy cover
The HDD dummy covers come pre-installed on the front panel bezel. In case you
removed the covers, follow these steps to re-install them.
To install an HDD dummy cover:
1.
From the inside of the front panel
assembly, insert the flat end of a
dummy cover into the slot as shown.
The end with the hook tab should be
close to the front panel LEDs.
2.
Press the dummy cover into the slot
opening until the hook tab clicks in
place.
3.
When installed, the dummy cover
appears as shown.
2-20
Hook tab
Flat end
Chapter 2: Hardware setup
Advertisement
Table of Contents
