Table of Contents
Advertisement
Restore on AC Power Loss [Last State]
When set to Power Off, the system goes into off state after an AC power loss.
When set to Power On, the system goes on after an AC power loss. When set to
Last State, the system goes into either off or on state, whatever the system state
was before the AC power loss.
Configuration options: [Power Off] [Power On] [Last State]
Resume On Ring [Disabled]
When set to [Enabled], the system enables the RI to generate a wake event while
the computer is in Soft-off mode. Configuration options: [Disabled] [Enabled]
Resume On LAN [Disabled]
When set to [Enabled], the system enables the LAN to generate a wake event
while the computer is in Soft-off mode. Configuration options: [Disabled] [Enabled]
Resume By PME# [Disabled]
When set to [Enabled], the system enables the PME to generate a wake event
while the computer is in Soft-off mode.
Configuration options: [Disabled] [Enabled]
Resume By RTC Alarm [Disabled]
Allows you to enable or disable RTC to generate a wake event. When this item is
set to [Enabled], the items RTC Alarm Date, RTC Alarm Hour, RTC Alarm Minute,
and RTC Alarm Second appear with set values.
Configuration options: [Disabled] [Enabled]
The following items appear only when the Power On RTC Alarm item is set to
Enabled.
RTC Alarm Date (Days) [15]
To set the alarm date, highlight this item and press the <+> or <-> key to
make the selection. Configuration options: [Everyday] [1] [2] [3]...[31]
System Time [12:30:30]
To set the alarm time, highlight this item and press the <+> or <-> key to
make the selection.
5-30
Chapter 4: BIOS setup
Advertisement
Table of Contents
