Audio Devices - Snom 300 User Manual

s n o m 3 x 0 V o I P P h o n e s
(2g) Message LED
The "Message LED" is primarily used to visually indicate new voice messages stored on
the mailbox of your PBX, (see page 87 "Voice Mailbox").
When the following setting on your phone's web user interface is set to "ON", it can
also be used to indicate the activities of your monitored extensions (Dialog State
page 89 "Extension Monitoring and Call Pickup") and to visually indicate missed calls.
Setup Preferences
Message LED for Dialog State/Missed Calls
Message Type
MWI
Incoming Call
Missed Call
Dialog State
Info Message
(2h) Call Indication LED
The "Call Indication LED" is only available on the snom 370. It indicates incoming calls
by a flashing red light.

(3) Audio Devices

Your phone is equipped with two different audio devices:
•
Casing speaker (3a) and microphone (3b)
•
Handset speaker (3c), microphone (3d), and hook switch (3e)
Optionally a headset can be attached as an additional audio device:
•
Headset speaker and microphone
The audio Devices can be used in three operation modes:
Handset mode
1. activates handset audio devices.
Headset mode
2. activates headset audio devices.
Handsfree mode
3.
For information on switching audio operation modes, see page 71.
one microphone
You can only use
for listening:
• Handset speaker / casing speaker or
• Headset speaker / casing speaker
For further details see page 73.
© snom technology AG 2007
U s e r M a n u a l
General Information
: <ON>
snom 300 - snom 320 – snom 360
yellow (blinking)
yellow (blinking)
yellow (steady)
yellow (blinking)
-
activates casing audio devices.
for talking, but you can choose uo to
E n g l i s h
see
snom 370
red (blinking)
- (see 2h)
yellow (steady)
yellow (blinking)
-
two speakers
Overview
• 9