Table of Contents
Advertisement
" + " and " - " buttons: stimulations level control buttons
Use the " + " and " - " buttons for rapid adjustment of the stimulation level of the receiver collar.
15 levels are available.
Level 1: very weak stimulations – Level 15: strong stimulations
Always start with the lowest level of stimulation.
button: high luminosity LED
If you press the
button, you will activate a blinking red high luminosity LED on the collar for approximately 8
minutes.
If you press the
button again before the 8 minutes are over, you will stop the LED.
Checking/replacing battery of remote control
●
Performance (radio range) of the remote control may deteriorate as battery becomes weak. Be prepared to replace
the battery.
To check the condition of the battery, turn On the remote control and look at the battery level indicator on the LCD
screen.
The symbols which appear indicate the following:
Battery fully charged
Weak battery: prepare to replace the battery
Dead battery: your EXPERT 600 switches to safety mode and the system locks up. The battery must be
replaced.
NUM'AXES advises to use the same type and same brand of batteries as those supplied in your new
purchased product. Other brands of batteries may not operate, or may not be completely compatible with
your product. You can purchase the suitable batteries from NUM'AXES or from your distributor.
Replace the batteries as follows:
on the back of the remote control, use a coin to turn the battery cover counter-clockwise and remove it (ref.
diagram 6)
remove the old battery
insert the new battery (lithium 3V CR2) paying attention to follow polarity indicated on the battery
housing
put the battery cover back in place making sure the seal is in the correct position in the remote control (ref.
diagram 6)
use a coin to close the battery cover
check that the remote control operates correctly
Use a coin to turn the battery cover
counter-clockwise then slightly incline
User's guide EXPERT 600 – indice A
Diagram 6
the coin to remove it.
WARNING
Make sure the polarity
is correct
-
Polarity «
» of the battery
Make sure the seal is in
the correct position
inside the remote
control before replacing
the battery cover
+
Polarity «
» of the battery
7/12
Advertisement
Table of Contents
