Table of Contents
Advertisement
First use from new
●
Charge of the EXPERT collar
To charge your collar, proceed in the following way:
connect the charger to a wall outlet
connect the power cord to the collar, after a few seconds, the green indicator light starts blinking
when the battery is fully charged, the green indicator light goes out
disconnect the charger from the collar and put the protection tab back in place
disconnect the charger from the wall outlet
We advise you to fully charge the battery before the 1
A full charge takes approximately 3 hours.
You can purchase a car charger from your supplier at any time.
Activate/deactivate the remote control
Remote control is supplied with battery fitted.
Activate: firmly press the On/Off button
▪
diagram 1). Indications appear on the LCD screen.
Deactivate: firmly press the On/Off button
▪
To increase the battery life, we recommend you to deactivate the remote control if you are not using it for
a long period.
Activate/deactivate the collar
You can activate/deactivate the collar with the magnetic key or with the remote control.
Activate/deactivate the collar with the magnetic key
Activate: move the magnetic key towards the collar so that it comes into contact with the red mark, hold for 1
▪
second (ref. Diagram 4). The green indicator light on the collar will flash indicating that the collar is On.
Deactivate: move the magnetic key towards the collar so that it comes into contact with the red mark, hold
▪
for 1 second (ref. diagram 4). The green indicator light on the collar flashes quickly then goes out indicating
the collar is Off.
To increase the battery life, we recommend you to deactivate the collar if you are not using it for a long
period.
User's guide EXPERT 600 – indice A
st
use.
located on the side of the remote control for 1 second (ref.
for 1 second. The LCD screen goes out.
Diagram 4
Activate/deactivate the receiver
collar with the magnetic key
4/12
Advertisement
Table of Contents
