Coding Of The Remote Control And Receiver Collar - Num'axes Expert 600 User Manual

 Activate/deactivate the collar with the remote control
A magnet located in the remote control is used to switch the EXPERT receiver collar On or Off.
Activate: move the remote control towards the collar so that the magnet position indicator comes into contact
▪
with the red mark on the collar, hold for 1 second (ref. Diagram 5). The green indicator light on the collar will
flash indicating that the collar is On.
Deactivate: move the remote control towards the collar so that the magnet position indicator comes into
▪
contact with the red mark on the collar, hold for 1 second (ref. diagram 5). The green indicator light on the
collar flashes quickly then goes out indicating the collar is Off.
To increase the battery life, we recommend you to deactivate the collar if you are not using it for a long
period.
Place these two areas
together for 1 second
 Coding the remote control and receiver collar
Each remote control has its own individual radio operator code. The coding of the remote control with the receiver
collar enables the two units to work together.
IMPORTANT: before beginning the coding (first use of the receiver collar or re-coding), make sure no
other person is using his EXPERT 600 or other products from the NUM'AXES range close by: your receiver
collar could accidentally record the code of his remote control. If that occurs, re-code the remote control
with your receiver collar.
CODING PROCEDURE FOR THE 1ST USE
1. Activate the remote control: press for 1 second the On/Off button
2. Activate the receiver collar: move the remote control towards the collar so that the magnet position indicator
comes into contact with the red mark on the collar, hold for 1 second (ref. Diagram 5).
3. Move the remote control away from the receiver collar.
4. Press the V (vibration) button of the remote control. The collar emits vibrations; it is then synchronized with
your remote control.
RE-CODING PROCEDURE (for all codings other than the 1st)
1. Activate the remote control: press for 1 second the On/Off button
2. Receiver collar in position "deactivated" (green indicator light Off): move the remote control towards the
collar so that the magnet position indicator comes into contact with the red mark on the collar, hold for 6
seconds. The indicator light on the collar lights in fixed green then goes out.
3. Move the remote control away from the receiver collar.
4. Press the V (vibration) button of the remote control. The collar emits vibrations; it is then synchronized with
your remote control.
User's guide EXPERT 600 – indice A
Diagram 5
Activate/deactivate the receiver
collar with the remote control
.
.
5/12