Reprogram A Receiver Collar; How To Use The Remote Control - Num'axes Expert 600 User Manual

 Reprogram a receiver collar
The receiver collar can be re-coded indefinitely, either with the same remote control, or with a new one from
the EXPERT range (ref. Re-coding procedure).
WARNING:
The EXPERT receiver collar will not work with a remote control from the CANICOM range.
The CANICOM receiver collar will not work with a remote control from the EXPERT range.

How to use the remote control

●
The EXPERT 600 remote control is designed to operate with 1 receiver collar.
 V button: vibration button
If you press the V (vibration) button the collar will emit vibrations. There is no time limit for this function: the collar
will continue to vibrate for as long as the button is pressed.
A transmission symbol
from flashing green to permanent green for as long as the button is pressed.
It's up to you to use the vibrations depending of the way you want to train your dog.
With the vibrations you can:
- send vibrations to your dog when it is disobedient
- draw its attention...
It's very important to always use the vibrations in the same way in order not to disturb your dog.
 F button: flash stimulations
Press the F button to send a warning to your dog using flash stimulations transmitted by the two contact points
located on the receiver collar for a defined length of time of less than one second.
A transmission symbol
from flashing green to permanent green while the stimulations are being sent.
 C button: continuous stimulations
Press the C button to send a warning to your dog using continuous stimulations transmitted by the two contact points
located on the receiver collar, this will last for as long as the button is pressed but limited to 8 seconds maximum.
A transmission symbol
from flashing green to permanent green while the stimulations are being sent.
If you press the C button for more than 8 seconds, the symbol
control and the collar will automatically go into safety mode for a few seconds before restarting itself normally.
 B button: booster
Press the B (booster) button to stop your dog instantaneously.
You can choose the stimulation level you think to be the best for an immediate effect. As a result, you do not need to
press the "+" button.
Those stimulations are transmitted by the two contact points located on the collar for as long as the button is pressed
but no more than 8 seconds maximum.
If you press the B (booster) button for more than 8 seconds, the symbol
remote control and the collar will automatically go into safety mode for a few seconds before restarting itself
normally.
Configuration of the B (booster) button:
 select the stimulation level 1
 press the "-" button until the stimulation level flashes on the LCD screen
 press the " + " or " - " button to modify the stimulation level
 press the B (booster) button to confirm the level selected
User's guide EXPERT 600 – indice A
will appear on the LCD screen of the remote control. The indicator light on the collar goes
will appear on the LCD screen of the remote control. The indicator light on the collar goes
will appear on the LCD screen of the remote control. The indicator light on the collar goes
will appear on the LCD screen of the remote
will appear on the LCD screen of the
6/12