Reprogram A Receiver Collar - Num'axes Canicom 5.201 Instruction Manual

3. Receiver collar in position "deactivated" (indicator light off): move the remote control towards the
collar so that the magnet position indicator comes into contact with the
collar for 6 seconds (Ref. Diagram 6). The indicator on the collar lights in fixed green then flashes in red.
4. Move the remote control away from the receiver collar.
5. Press the vibration button
with your remote control.
If you have several collars, renew the same procedure for each one.
 Reprogram a receiver collar
The CANICOM 5 receiver collar can be re-coded indefinitely, either with the same remote control, or with a new
remote control from the CANICOM 5 range (Ref. Coding procedure).
How to use the remote control
●
The CANICOM 5.201 remote control is designed to operate with only 1 receiver collar.
The CANICOM 5.202 remote control is designed to operate with 1 or 2 receiver collars.
The CANICOM 5.500 remote control is designed to operate with 1 or 2 receiver collars.
The CANICOM 5.800 remote control is designed to operate with 1 or 2 receiver collars.
The CANICOM 5.1500 remote control is designed to operate with 1, 2, 3 or 4 receiver collars.
For CANICOM 5.202, CANICOM 5.500, CANICOM 5.800 and CANICOM 5.1500, before sending any
training instruction (beep sound, vibration or static stimulation), you have to select the dog you want
to send a message to.
In order to select the dog, use the
 on the CANICOM 5.202, CANICOM 5.500 and CANICOM 5.800 remote controls, the symbol
appears on the LCD screen.
 on the CANICOM 5.1500 remote control, the symbol
NOTE: for CANICOM 5.201, you don't have to select a collar because there is only one.
button: beep sounds

If you press the button, the receiver collar will emit beep sounds. There is no time limit for this function: the
collar will continue to beep for as long as the button is pressed.
It's up to you to use the beep sounds depending on the way you want to train your dog.
With the beep sounds you can:
- send a warning to your dog when it is disobedient,
- draw its attention ...
It's very important to always use the beep sounds in the same way in order not to disturb your dog.
button: vibrations (pager)

If you press the
collar will continue to vibrate for as long as the button is pressed but no more than 8 seconds maximum.
If you press the button for more than 8 seconds, the collar will automatically go into safety mode for a few
seconds before restarting itself normally.
It's up to you to use the vibrations depending on the way you want to train your dog.
With the vibrations you can:
- send a warning to your dog when it is disobedient,
- draw its attention ...
It's very important to always use the vibrations in the same way in order not to disturb your dog.
CANICOM 5 range - user's guide– indice A
of the remote control. The collar emits vibrations; it is then synchronized
or button of the remote control:
button, the receiver collar will emit vibrations. There is no time limit for this function: the
symbol located on the receiver
3 or
,
1 2, 4
1
appears on the LCD screen.
or
2
6/12