First Use From New - Num'axes Easy Dog Soft User Manual

Presentation
Red indicator lights:
radio transmission
indicators + stimulation
level indicators
+ battery level indicators
High
luminosity
LED button
Long
vibration
button
Round mark:
magnet position indicator
This magnet allows you to switch On/
Off the collar and to code the collar
with the remote control.

First use from new

Fitting the battery in the EASY DOG receiver collar
- Unscrew the 4 screws of the top of EASY DOG using a screwdriver.
- Insert the battery (3-V Lithium CR2) paying attention to follow polarity indicated on the battery housing
(ref. Diagram 5).
- A beep sound (low pitch) is emitted, indicating the correct installation of the battery.
If you do not hear any beep after having inserted the battery, remove it immediately from its housing.
Check the polarity before trying again.
- Before putting the lid back in place, check that the rubber seal is in its groove.
- Screw up the 4 screws with care (do not overtighten them).
Gb - 22
White mark:
area where the On/Off
switch magnet is located
Beeper button
Stimulation
button
Diagram 3
EASY DOG SOFT
Remote control
Contact points
(short or long)
Indicator light:
On/Off indicator
+ radio reception
indicator
+ battery level
indicator
Area where the
high luminosity
LED is located
Diagram 4
Collar