Table of Contents
Advertisement
Microphones
STEP 5- CONNECT A MIC TO THE CONSOLE
Using a mic to XLR cable, connect a mic to the Mic 1 input on the console.
Turn Channel One on (the red LED should be on) and set the channel one fader to the in hand position (middle). If the mic itself has an on/off switch, then turn
it on.
TEST- Speak into the microphone and the console VU meters should follow your voice. There should be no audio out of the monitor speakers (they are muted
to eliminate feedback) but there should be audio in the Headphones.
If mic level is low, refer to "Calibration" later in this section.
STEP 5- CONNECT A MIC TO THE CONSOLE
Cue
Ch 14
Air
Mon
ARC-15BP
L
L
L
Headphone
RS232
R
R
R
Logic
In
DC Power
In
In
Out
I N S T A L L A T I O N I N S T R U C T I O N S
PMM
Aud
Pgm
Phone Logic
Pgm Left
Pgm Rght
Phone
L
L
R
R
Ground
Out
Out
AMM
Out
Out
Out
Back panel Diagram for ARC-15BP console
Ch 15 Phone
Ch 14
Ch 13
Ch 12
Ch 11
Ch 10
Ch 9
Ch 8
Mic Ch 5
PC
48V
In
USB
pwr
In
4.6
Connect a mic to the
XLR mic inputs and
test the mic
into the headphones
Ch 7
Ch 6
Ch 5
Ch 4
Ch3
Ch 2
Mic Ch 3
Mic Ch 4
In
MIC ONE
Mic Ch 2
Mic Ch 1
Arrakis
Systems
In
In
In
Advertisement
Table of Contents
