Checking The Device Operates Correctly; Checking / Replacing Battery - Num'axes Canicalm User Manual

Hide thumbs Also See for Canicalm:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 8
Fig. 1
Fig. 2

Checking the device operates correctly

Before doing so, make sure the collar is turned Off. Fix each wire of the neon test lamp under
each contact point (unscrewing them lightly and then retightening them so as to pinch the test
lamp wires). Position the stimulations switch on short or long stimulation then switch On the
collar. Make a streaked object slide over the bark detection contact point (e.g. sleeve isolated
knife with teeth). The test lamp will light indicating the collar is operating correctly.

Checking / replacing battery

Should the level of the battery come down, the collar emits a continuous beep. Turn the On/Off
switch to Off. Open the box by removing the screw on the cover, opposite the contact points.
Remove the used battery and insert the new one paying attention to follow polarity indicated
on the battery housing.
Put the cover back on the box. Turn the switch On and after a few seconds, a beep sound of
1 second will be emitted, indicating that the collar is correctly initialised. You will be able to
obtain 3V lithium CR 123 A batteries from your supplier.
GB
10

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents