dbx DriveRack 260 User Manual page 33

DriveRack
POST EQ
• You are now in the Post-Crossover EQ module. The arrow indicates that EQ type is
selected. Rotate the DATA wheel to select the Parametric EQ type. Use the PREV
PG and NEXT PG buttons to move through outputs 1-6, and then to the next mod-
ule screen which will appear something like this:
• You are now in the Post-Crossover Dynamics module. The arrow indicates that that
either the Limiter or AGC type is selected. Rotate the DATA wheel to select the
Dynamic type. Use the PREV PG and NEXT PG buttons to move through outputs
1-6, and then to the next module screen which will appear something like this:
MONO DLY 20 MS
810 ms Unused
• You are now in the Post-Crossover Delay module. The arrow (in correspondence
with the with the output 1-6 indicators indicate which output delay module block is
currently selected. Rotate the DATA wheel to select Delay type and time. Pressing
and then rotating the DATA wheel lets you link or unlink the output delay1-6 mod-
ules. Use the PREV PG and NEXT PG buttons to move through Outputs 1-6, and
then to the next module screen which will appear something like this:
OUTPUT CH2
NAME Output Ch2
<STORE>-EDIT NAME
• You are now in the Output Route and naming module. The arrow (in correspon-
dence with the with the output 1-6 indicators indicate which output module block is
currently selected. Rotate the DATA wheel to select Output route. Pressing the
STORE button will move you to naming page which appears something like the
following display:
®
™
Configuring the DriveRack™
Link/Unlink
LIMITER
Select
Link/Unlink
Select
Link/Unlink
Route
P 2
2
P
P
3
4
P
P
5
6
P
L 2
2
L
L 3
4
L
L
5
6
L
D 2
2
D
D
3
4
D
D 5
6
D
2
2
3
4
5
6
DriveRack™ User Manual
Section 3
25