250
4-3. Operating the lights and wipers
Temporarily lowering sensor sensitivity
■
The sensitivity of the sensor can be temporarily lowered.
Turn the engine switch off while the following conditions are met.
1
• The headlight switch is in
• The headlight switch lever is in high beam position.
• Automatic High Beam switch is on.
Turn the engine switch to IGNITION ON mode.
2
Within 5 seconds after
3
original position then pushing it to the high beam position quickly 9 times,
then leave the lever in high beam position.
Automatic High Beam (headlights) may turn on even the vehicle is stopped.
If the Automatic High Beam indicator turns to yellow
■
It may indicate a malfunction in the system. Contact your Toyota dealer.
HIGHLANDER_U (OM48A12U)
or
.
, repeat pulling the headlight switch lever to the
2