Toyota 2014 highlander Manual page 239

248
4-3. Operating the lights and wipers
Turning the high beam on/off manually
Switching to low beam
■
Pull the lever to the original
position.
The Automatic High Beam indi-
cator will turn off.
Push the lever away from you to
activate the Automatic High
Beam system again.
Switching to high beam
■
Press the
Beam switch.
The Automatic High Beam indi-
cator will turn off and the high
beam indicator will turn on.
Press the switch to activate the
Automatic High Beam system
again.
The Automatic High Beam can be operated when
■
The engine switch is in IGNITION ON mode.
Camera sensor detection information
■
High beam may not be automatically turned off in the following situations:
●
• When oncoming vehicles suddenly appear from a curve
• When the vehicle is cut in front of by another vehicle
• When oncoming or preceding vehicles are hidden from sight due to
repeated curves, road dividers or roadside trees
High beam may be turned off if an oncoming vehicle that is using fog lights
●
without using the headlights is detected.
House lights, street lights, red traffic signals, and illuminated billboards or
●
signs may cause the high beam to turn off.
HIGHLANDER_U (OM48A12U)
Automatic High