Installing A Built-In Coffee Machine - Miele CVA 3650 Operating And Installation Instructions

Installation

Installing a built-in coffee machine

Before installation make sure that
there is no power supply to the
machine. This also applies should it
ever need to be taken out of its
housing unit.
The machine may only be used
when it has been built in. It can only
be used in areas with an ambient
temperature of +15 °C to +60 °C.
You will need two Allen keys (size 3
and 5) for installing the machine.
^ Push it all the way into the niche until
you feel resistance.
The following only applies when
installing in a tall unit:
^ Check the height of the machine to
make sure that it is sitting centrally in
the niche and that it is level.
If this is not the case, realign the 4
feet underneath the machine using
the large allen key.
The feet can be unscrewed by up to
approx. 10 mm.
68
For units with 19 mm thick side
walls:
^ If the furniture unit walls are 19 mm
thick you will need to drill four holes
in the sides for securing the machine.
To mark the position of these holes:
– Align the machine in the niche.
Screw the side socket screws inside
the machine in a little so that they
make indents in the side walls, and
then unscrew them again.
– Take the machine out of the niche
and drill ø 4.5 mm holes, 2 mm deep
where you made the indentations.