Display Setting - Ribao BC2000-US Series Operation Instructions Manual

select LEVEL 2→LEVEL 3→OFF→LEVEL 1→LEVEL 2(the LEVEL 1 indicates a LOWEST detection
sensitivity, the LEVEL 2 indicates a STANDARD detection sensitivity, and the LEVEL 3 indicates the
HIGHEST detection sensitivity), After setting, press ESC to exit or continue the next setting, or press
to go back to previous setting.
5) Press key, the cursor moves to next line, that is MG detection sensitivity setting: Press SET key
(For bills with a low magnetic response)
to select LEVEL 1
magnetic response)
setting, press ESC to exit or continue the next setting, or press
When the machine leaves the factory, the Default Functions are set as follows:
Auto Start
Width Detection
Double Detection
UV Detection
Magnetic Detection
Counting Speed
Counting Mode
Accumulation Counting
How to get back to the default setting:
Keep pressing RESET key for 3 seconds, the display shows DEFAULT..., which means it is resuming

Display setting


In Normal mode and Value mode( Fig.1 , Fig.2), press RESET key to switch the display mode, as
Fig.5, Fig.6, Fig.7
→LEVEL 3(
For bills with a high magnetic response)
→LEVEL 2
to go back to previous setting.
ON
5 mm
A
Level 2
Level 1
1100 pieces/minute (Standard)
Continuous Counting
OFF
Fig.5
10
(For bills with a normal
→OFF→LEVEL 1. After