Volkswagen Information System - Volkswagen Polo 2015 Owner's Manual

12/29/2015
The number of kilometres or amount of time until the next oil change service is shown in the display, followed by the same information for
the next inspection.
Service information → Fig. 14
Service
function buttons
An overdue service is indicated by a minus sign in front of the mileage or trip reading.
Resetting oil change service
If the oil change service was not performed by a Volkswagen workshop, it can be reset as follows:
Switch off the ignition.
Press and hold down the
Restart the ignition.
Release the
Confirm the query in the instrument cluster with the
Do not reset the display between service intervals. This can lead to incorrect information being displayed.
If you manually reset the service interval display while flexible oil change service is valid, fixed oil change service will be activated. The service
interval will no longer be calculated on an individual basis ⇒ Booklet Service schedule , .
Resetting inspection
If the inspection was not performed by a Volkswagen workshop, it can be reset as follows:
Switch off the ignition.
Press and hold down the
Restart the ignition.
Release the
Confirm the query in the instrument cluster with the
The service message will go out after a few seconds once the engine is running or by pressing the
→ Instrument overview
If the vehicle battery is disconnected for long periods in a vehicle with flexible oil change service, the system will not be able to calculate
the time when the next service is due. The service displays could then display incorrect information. If this is the case then please observe the
maximum service intervals shown in ⇒ Booklet Service schedule , .

Volkswagen information system

Introduction
This chapter contains information on the following subjects:
→ Overview of the menu structure
→ Using the selection menu in the instrument cluster
→ Selection menu
Bedienungsanleitung < Service & Zubehör < Volkswagen Deutschland
can also be displayed in the infotainment system by pressing the
→ Menu and system settings (SETUP)
button in the instrument cluster
button.
button in the instrument cluster
button and press it again.
button.
.
→ Instrument overview
button.
→ Instrument overview
button.
button and the
.
.
/
and
21/32