Volkswagen Polo 2015 Owner's Manual page 29

12/29/2015
Select the memory that you wish to delete.
Press and hold the
wheel, for approximately 2 seconds.
Personal selection of displays
You can set which MFD display should appear in the instrument cluster using the
Multifunction display
Examples of display
Display
Consumption
Av. consumption
Range
Travel time
Distance
Av. speed
Digital speed display
Speed warning --- km/h
or Warning at --- mph
Oil temp.
Coolant
Saving a speed for the speed warning
Select display warning at --- km/h or Warning at --- mph.
Press the
save the current speed and activate the warning system.
If necessary, use the
steering wheel, within approximately 5 seconds to set the desired speed. Then press the
or wait a few seconds. The speed is now saved and the warning is activated.
To deactivate , press the
a)
Changes depending on the instrument cluster version.
Assist systems menu
First read and observe the introductory information and safety warnings
Menu Function
Bedienungsanleitung < Service & Zubehör < Volkswagen Deutschland
button on the windscreen wiper lever, or the
function buttons in the infotainment system
Function
The current fuel consumption is displayed in litres/100 km while the vehicle is in motion, and in litres/hour while
the vehicle is stationary.
The average fuel consumption will be shown after a distance of approximately 300 metres has been travelled.
The display will show dashes until this point. The displayed value is updated approximately every second.
Approximate calculation of the distance in km that can still be travelled with the current fuel level under the
current driving conditions. One factor used for calculating this figure is the current level of fuel consumption.
Driving time in hours (h) and minutes (min) that has elapsed since the ignition was switched on.
The distance travelled in km since the ignition was switched on.
The average speed will be shown after a distance of approximately 100 metres has been travelled. The display
will show dashes until this point. The displayed values will be updated approximately every 5 seconds.
Current vehicle speed displayed digitally.
If the saved speed (within the range of 30 km/h (18 mph) and 250 km/h (155 mph)) is exceeded, a signal tone
will be given, along with a visible warning if required.
Current temperature of the engine oil displayed digitally.
Current coolant temperature displayed digitally.
button on the windscreen wiper lever, or the
rocker switch on the windscreen wiper lever, or the
or
button and the
→ Menu and system settings (SETUP)
button. The stored speed will be deleted.
→
button on the multifunction steering
and
.
button on the multifunction steering wheel to
or buttons on the multifunction
or
Introduction
button again,
26/32