Jøtul F 400 Castine Installation And Operation Instructions Manual page 2

139680-R00 F 400 Castine May 2015
Installation and Operation Instructions
for USA/Canada
Safety Notice: If this solid fuel room heater is not properly
installed, a house fire may result. For your safety, follow
the installation directions. Contact local building or fire
officials about restrictions and installation inspection
requirements in your area.
This manual describes the installation and operation of
the Jøtul F 400 non-catalytic wood heater. Read this entire
manual before you install and use your new stove. Save
these instructions for future reference.
This wood heater needs periodic inspection and repair for
proper operation. See this manual for specific information.
It is against federal regulations to operate this wood
heater in a manner inconsistent with the operating
instructions in this owner's manual.
Standards
The Jøtul F 400 Castine solid fuel heater has been tested
and listed to :
U.S. Standards: ANSI/UL 737 and ANSI/UL 1482.
Canadian Standards:
CAN/ULC-S627-M00 and CAN/ULC-S628-M93
Certified Safety Tests performed by:
Intertek Testing Services, Middleton, Wisconsin U.S.A.
Manufactured by:
Jøtul North America, Inc.
55 Hutcherson Drive
Gorham, Maine 04038, USA
and
Jøtul AS, P.O. Box 1411, Fredrikstad, Norway
Distributed by:
Jøtul North America, Inc.
55 Hutcherson Drive
Gorham, Maine 04038, USA
Combustion Specifications
Heat Output*: Under specific test conditions, this
heater has been shown to deliver heat ranging from
11,300 to 27,800 BTU's.
Efficiency*:
CO Emissions:
Pariculate Emissions:
* Default values per previous Federal Register 40 CFR Part
60, Subpart AAA.
EPA validated efficiency and CO values were unavailable
at the time of this printing. These values will be made
available in the manual and on the Jotul website (www.
jotul.us) for your reference in the near future.
2
63%
N/A
3.8 g/h
WARNING !
THIS WOOD HEATER HAS A MANUFACTURER-
SET MINIMUM LOW BURN RATE THAT MUST
NOT BE ALTERED. IT IS AGAINST FEDERAL
REGULATIONS TO ALTER THIS SETTING
OR OTHERWISE OPERATE THIS WOOD
HEATER IN A MANNER INCONSISTENT WITH
OPERATING INSTRUCTIONS IN THIS MANUAL.
This heater meets the 2015 U.S.
Environmental Protection Agency's
emission limits for wood heaters
manufactured after May 15, 2015.
This heater may not to be sold after
May 15, 2020.
See Sect. 5.0 of this manual for important information
regarding the safe, proper, and most efficient operation
of your stove.
Check Building Codes
When installing, operating and maintaining your Jøtul
F 400 woodstove, follow the guidelines presented in
these instructions, and make them available to anyone
using or servicing the stove.
Your city, town, county or province may require a
building permit to install a solid fuel burning appliance.
In the U.S., the National Fire Protection Association's
Code, NFPA 211, Standards for Chimneys, Fireplaces,
Vents and Solid Fuel Burning Appliances, or similar
regulations, may apply to the installation of a solid fuel
burning appliance in your area.
In Canada, the guideline is established by the CSA
Standard, CAN/CSA-B365-M93, Installation Code for
Solid-Fuel-Burning Appliances and Equipment.
Always consult your local building inspector or
authority having jurisdiction to determine what
regulations apply in your area.