Table of Contents
Advertisement
◆ Selecting the color temperature (COLOR TEMP.)
You can select a preset color temperature (white tone) using the menu (see page 23).
1. Display the IMAGE menu.
2. Select COLOR TEMP. by pressing the
3. Select your desired color temperature by pressing the
To exit from the menu:
4. Press the MENU button several times.
◆ Customizing the color temperature (COLOR TEMP.)
To customize and store the color temperature, carry out the following procedure.
1. Select COLOR TEMP. in the IMAGE menu.
2. Press the
3. Press the ENTER button.
• The COLOR TEMP. - CUSTOM menu appears as shown.
COLOR TEMP. - CUSTOM
CONTRAST R
CONTRAST G
CLAMP WIDTH
CONTRAST B
BRIGHTNESS R
BRIGHTNESS G
BRIGHTNESS B
4. Press the
CONTRAST R (red), CONTRAST G (green),
CONTRAST B (blue), BRIGHTNESS R (red),
BRIGHTNESS G (green), and BRIGHTNESS B (blue).
5. Press the
item.
About color temperature
There are different kinds of white color. Color temperature is a way to show the differences in white. With the higher color temperature, white
area of the image appears reddish, with the lower color temperature, white area of the image appears bluish. This projector adjusts the color
temperature by changing the values of the blue and red contrasts.
To raise the color temperature:
Increase the CONTRAST B (blue) and decrease the CONTRAST R (red).
To reduce the color temperature:
Decrease the CONTRAST B (blue) and increase the CONTRAST R (red).
Important
• If you set all of CONTRAST R, G and B to negative value, the original brightness of the image can not be obtained even
when you maxmize CONTRAST in the IMAGE menu.
28
Downloaded from
www.Manualslib.com
or
or
button to select CUSTOM
0
0
1
0
0
0
0
or
button to select an item from
or
button to adjust the value of each
manuals search engine
button.
or
button.
6. Repeat step 4 and 5 for optimum adjustment results.
.
To exit from the menu:
7. Press the MENU button several times.
To activate the stored color temperature settings:
1. Press C.TEMP on the remote control.
• The current setting appears.
COLOR TEMP.
2. Press the
COLOR TEMP.
To exit from the menu:
3. Press the C.TEMP button on the remote control.
http://www.pureglare.com.au
:
NATIVE
or
button to select CUSTOM
: CUSTOM
.
Advertisement
Table of Contents
