Table of Contents
Advertisement
14
Indicators
This projector has two indicators, each of which shows the operation condition of the projector.
Refer to Troubleshooting for additional indication signals.
◆ Normal conditions
POWER
Steady red
Steady green
Steady green
Steady red
◆ Abnormal conditions
POWER
Steady green
or
Steady red
Steady red
Steady green
Blinking green/red
Steady red
Steady red
Blinking
green/red
Blinking
Steady or Blinking
green/red
*1: When LAMP MODE of the SETUP menu is set to CINEMA.
*2: When LAMP MODE is set to STANDARD, this duration will be decreased to 2000 hours.
38
Downloaded from
www.Manualslib.com
STANDBY/ON button
STATUS
Stand-by.
Off
Warming up period (about 1 minute).
Blinking green
The projector is ready.
Steady green
Cooling down period (lasts under 2 minutes; normal when
shutting down).
Blinking green
STATUS
Abnormal temperature
• The ventilation grilles are clogged with dust or dirt.
• The room temperature is high.
Blinking orange
Abnormal when it occurs except while shutting down. The
protection circuit is working or the lamp is in an abnormal
Blinking green
condition.
Lamp operation time warning. (Total lamp operation time
reached 2250 hours
Lamp operation time warning. (Total lamp operation time
reached 2250 hours
Blinking red
Lamp operation time warning. (Total lamp operation time
reached 3000 hours
Steady red
The lamp cover isn't closed.
Off
Abnormal.
manuals search engine
POWER indicator
STATUS indicator
CONDITION
CONDITION
*1
while the power was on.)
*1
while the power was off.)
*1, *2
while the power was off.)
http://www.pureglare.com.au
NOTE
The STANDBY/ON button cannot be used
until the STATUS indicator is steady green.
Do not unplug the projector until the
STATUS indicator is off.
SOLUTION
• Clean the ventilation grilles.
• Relocate the projector to a cooler place.
• Remove any objects blocking the
ventilation grilles.
• Wait until the STATUS indicator goes out,
then press the STANDBY/ON button.
• If the above solution is not effective,
replace the lamp.
Replace the lamp.
Change with a new lamp if this problem
recurs.
Close the cover correctly.
Contact your dealer.
Advertisement
Table of Contents
