Table of Contents
Advertisement
6
Projection
◆ Viewing video images
Preparation:
• Always remove the lens cap before operating the projector.
• Turn on the power of the connected video equipment.
D-SUB/HDMI
button
1. Confirm the POWER indicator lights up red.
• If the projector was turned off before the lamp was cooled down sufficiently last time, the fan may start rotating and the STANDBY/ON
button may not work after the power cable is plugged. (The STATUS indicator blinks green.) After the fan stops rotating, press the
STANDBY/ON button to turn back on the POWER indicator.
2. Press the STANDBY/ON (
• It may take about one minute for the lamp to light up.
• The lamp fails to light up on rare occasions. If this happens, wait for a few minutes and then try again.
• Do not cover the lens with the lens cap while the lamp is on.
3. Select an input source.
• Press the VIDEO/S/COMP. or D-SUB/HDMI button on the projector, or press one of the input selector buttons (VIDEO, S-VIDEO,
COMP., HDMI, or D-SUB) on the remote control to select the input you desire. Be sure to select the input source that is corresponding
to the terminal in use.
–The input source is switched to
–The input source is switched between D-SUB and HDMI at every press of the D-SUB/HDMI button on the projector.
• There may be a delay before an image is displayed on the screen depending on the type of the input signal.
• Some images become easier to view when the setting of aspect ratio is changed (see page 18).
4. Adjust the position of the projector to keep an appropriate projection distance with which images are projected in their
specified sizes.
5. Adjust the position of the projector so that the projector and the screen are perpendicular to each other (see page 8).
• When the projector cannot be positioned perpendicularly to the screen, adjust the projection angle (see page 8).
6. Adjust the size of the projected image by turning the ZOOM ring.
7. Adjust the focus by turning the FOCUS ring.
Repeat steps 4 to 7, if necessary.
Important
• When a 4:3 image is continuously displayed for a long time before displaying a 16:9 image, the afterimages of the black
bars on each side may appear on the 16:9 image screen. Consult your dealer in this case.
• Do not display a still picture for a long time because the afterimages may persist on the screen.
16
Downloaded from
www.Manualslib.com
FOCUS ring
ZOOM ring
STANDBY/ON
button
VIDEO/S/COMP.
button
) button on the projector or ON ( I ) button on the remote control.
VIDEO
S-VIDEO
,
manuals search engine
STANDBY/ON
POWER
STATUS
AUTO SYNC
ENTER
MENU
DIGITAL CINEMA PROJECTOR DPX-830
or COMPONENT at every press of the VIDEO/S/COMP. button on the projector.
http://www.pureglare.com.au
ON
POWER
STANDBY
ON (
)
I
button
ASPECT
AUTO
ASPECT
HIDE
NORMAL
SQUEEZ
S. ZOOM
HDMI button
HDMI
COMP.
VIDEO
INPUT
D-SUB button
D-SUB
S-VIDEO
ENTER
MENU
KEYSTN
MEMORY
1
2
3
CONT.
BRIGHT
C.TEMP
GAMMA
SHARP
IRIS
SETTING
RDP-81
COMP. button
VIDEO button
S-VIDEO button
Advertisement
Table of Contents
