Table of Contents
Advertisement
◆ TRIGGER terminal
The TRIGGER terminal on the rear of the projector is a terminal that outputs 12 V signal to control an externally connected equipment when
images are projected.
Ring (NC)
Sleave (ground 0 V)
◆ Plugging in the power cable
For US
AC IN
1. Plug the supplied power cable into the AC IN of this projector.
2. Plug the other end of the power cable into a power outlet.
• The power cables for use in the U.S. and Europe are included with this projector. Use the appropriate one for your country.
• This projector uses the power plug of three-pin grounding type. Do not take away the grounding pin from the power plug. If the power
plug doesn't fit your wall outlet, ask an electrician to change the wall outlet.
• The provided power cable for the U.S. is rated at 120 V. Never connect this cable to any outlet or power supply using other voltages or
frequencies than rated. If you use a power supply using other voltage than rated, prepare an appropriate power cable separately.
Downloaded from
www.Manualslib.com
HDMI
D-SUB
AC IN
SERIAL
USB
TRIGGER
To TRIGGER terminal
Tip (12 V)
Earthing
terminal
HDMI
D-SUB
SERIAL
USB
TRIGGER
1
Power cable
manuals search engine
To use the TRIGGER terminal, set TRIGGER OUT to ON in the
SETUP menu. (The factory default is OFF.) Use the following
steps to change the setting.
COMPONENT
With the SETUP menu:
Y
PB/CB
PR/CR
(See page 23 for menu setting.)
S-VIDEO
1. Display the SETUP menu.
VIDEO
2. Select TRIGGER OUT by pressing the
3. Select ON by pressing the
To exit from the menu:
4. Press the MENU button several times.
• Do not use the signal output from the TRIGGER terminal as
a power for other equipment.
• Do not link the TRIGGER terminal with an audio terminal
of other equipment. This may cause a damage.
• The rated current for the TRIGGER terminal is 200 mA. If
you use a current exceeding this rating, a failure may occur.
• For information about electric screens, please contact screen
manufacturers.
For Europe
AC IN
2
http://www.pureglare.com.au
or
button.
Earthing
terminal
HDMI
D-SUB
SERIAL
USB
TRIGGER
1
Power cable
or
button.
2
15
Advertisement
Table of Contents
