Trigger Out - Yamaha DPX-1100 Owner's Manual

NMain unit <Rear panel / Connections>
1 INPUT B (D-sub 15 pin)
Receives component video and RGB (RGB/YP
signals. Use a D-sub monitor cable to connect components to
this jack.
2 D4 VIDEO (D jack)
Receives signals output from the D jacks of other AV
components. It is compatible with D1 - D4 formats.
3 - 7 INPUT A (BNC jacks)
Receive component video and RGB signals. Connect
component signal connectors from AV components to input
jacks 3 - 5, and RGB signal connectors from computers to
input jacks 3 - 7. Use BNC cables for these connections.
3 G/Y
(G, or luminance signal)
4 B/P
/C (B, or color difference signal)
B B
5 R/P
/C (R, or color difference signal)
R R
6 HD/SYNC (Horizontal sync signal, composite sync signal)
7 VD
(Vertical sync signal)
8 S VIDEO (Mini DIN jack)
Receives signals from S-VIDEO output jacks of other AV
components. Use an S-VIDEO cable for these connections.
q
HDMI
INPUT B
RGB/YP P /YC C D4 VIDEO G/Y B/P /C
B R B R B B
1 2 3 4 5
P /YC C )
B R B R
Rear remote control sensor
w e
OUT IN
REMOTE RS-232C
INPUT A
R/P /C HD/SYNC VD S VIDEO
R R
6 7 8
9 AC inlet
Insert the supplied AC power cable here.
0 VIDEO (Pin Jack)
Receives composite video signals from the VIDEO output
jacks of other AV components. Use a video pin cable for these
connections.
q HDMI
TM TM
(HDMI jack)
Receives HDMI TM signals from computers or AV components.
w REMOTE IN / OUT jack
Connect the remote control to the REMOTE IN jack if you
want to use it through a cable. The REMOTE OUT jack
outputs the signal received through the REMOTE IN jack
without any change.
e RS-232C (D-sub 9 pin)
For use in servicing this unit.
r TRIGGER OUT
Outputs control signals to external components. This output
provides a potential of 12 V/ maximum 200 mA when this unit
is projecting. Use the supplied trigger-out DC plug (for US
model only) to control external components.
r

TRIGGER OUT

VIDEO
9 0
3
5