The correct temperature
Setting the temperature
^ Use the two sensors underneath the
display to set the temperature.
By touching the sensor
– the temperature will get colder
– the temperature will get warmer.
The temperature being set will flash in
the display.
The following information shows in the
display while the sensors are being
touched:
– Touching a sensor once: the last
temperature selected flashes.
– Each subsequent touch of the
sensor:
adjusts the temperature shown in
1 °C steps.
– Leaving a finger on the sensor:
changes the temperature
continuously.
22
Approximately 5 seconds after the last
time a sensor has been touched, the
current temperature inside the
appliance is automatically shown.
If you have adjusted the temperature,
wait for approx. 6 hours if the
appliance is not very full and for
approx. 24 hours if the appliance is
full before checking the temperature
display, as it will take this long for the
appliance to give an accurate reading.
If, after this time, the temperature is still
too high or too low, you will need to
adjust it again.
Temperature range
The temperature can be adjusted from
-15 °C to -28 °C.