Parmco PP0V-6S-DT-1 Installation And Operating Instructions Manual page 19

Step 1: Prepare for installation
Housing unit with internal height of 860 mm or more.
• Remove any fixings that may prevent entry of the
oven into the housing..
• When installed in a typical 600 mm deep built in
housing unit, the false back should be removed
from the housing unit to provide the necessary
depth for installation.
• When the false back is removed, it is normally
the case that the support shelf for the appliance
leaves a gap between the back edge and the wall
of approximately 80 mm.
• If no gap occurs between the back edge of the
shelf and the wall behind the unit, we recommend
that a gap of at least 30 mm is made by shortening
the shelf.
INSTRUCTIONS FOR THE INSTALLER
�������������
18
����������
��������������������������