Instructions For The Installer - Parmco PP0V-6S-DT-1 Installation And Operating Instructions Manual

TECHNICAL INFORMATION
All instructions related to installation and
maintenance operations listed in this section
must be carried out only by authorised
personnel.
The manufacturer cannot be held responsible
for any damage to persons or property resulting
from an incorrect installation of the appliance.
UNPACKING YOUr APPLIANCE
• Once the packaging has been removed, thoroughly
check that the appliance is in perfect condition. If
you have any doubts do not use the appliance and
call our Service Centre.
• Do not move the appliance by the handles.
• Some parts mounted on the appliance are protected
by a plastic film. This protection must be removed
before using the appliance. We recommend slitting
the plastic film along the edges with a sharp knife
or pin.
All packaging materials used (cardboard boxes,
bags, polystyrene foam, nails, etc.) must be
kept out of the reach of children, as they are a
potential hazard source. All packaging materials
used are environmentally-friendly and recyclable
(wooden bits are free from chemicals, cardboard
is 80-100% recycled, protective bags are made
in polyethylene (PE), bands in polypropylene
(PP) and padding in polystyrene foam (PS)
without chloro-fluoro-carbides. Waste materials
can undergo treatment and be recycled saving
on new raw materials and on the amount wasted
volumes. For this purpose we suggest you take
the packaging material back to the shop you
bought the appliance or to a collecting service.
Ask your local service for the nearest service.
WARNINGS
• As this is a built-in oven, please ascertain that
the walls or panels surrounding the appliance
can withstand a temperature of 95°C.
• Also make sure that the glue that joins the
laminated plastic coat to the unit can withstand
a temperature of around 150°C, to avoid the
laminated coat to unglue.

INSTRUCTIONS FOR THE INSTALLER

INSTALLATION INSTRUCTIONS
Before you start - please read the instructions care-
fully - planning your installation will save you time and
effort.
Leave the appliance in the base tray packaging until
you are ready to install it.
When you remove the appliance from the base tray
packaging, take care not to damage it.
Whilst every care is taken to eliminate burrs and raw
edges from this product, please take care when han-
dling – we recommend the use of protective gloves
during installation.
Please note that the weight of this appliance is ap-
proximately 55 kg (unpacked). Take care when lifting
it into the housing unit
- always use an appropriate method of lifting.
Please note that all dimensions and sizes given are
nominal, some variation is to be expected. If this ap-
pliance is to be installed near to a corner where the
adjacent cabinets run at right angles forward of the ap-
pliance, there must be a gap of at least 90mm between
the appliance and the cabinets, to prevent overheating
of the cabinets.
Important: Do not modify the outer panels of
this appliance in any way.
Fixing screws - The fixing screws are in a polythene
bag in the oven pack.
17