Functions For Events [Event] - Panasonic WJ-HD309A Network Set Instructions

Functions for events [Event]

Perform the settings for event actions of each event type (motion detection, video loss, terminal alarm and command
alarm). Refer to the provided operating instructions for further information about each event type.
Basic settings for event actions [Event Setup]
Perform the settings for event actions such as alarm output duration and buzzer duration of each camera channel for
each event type (motion detection, video loss, command alarm and terminal alarm).
Important:
Alarm output duration can not be set for video loss. Signals will be supplied continuously from the camera error
output terminal (pin no. 17) of the ALARM/CONTROL connector on the rear panel during the period when the
video signal is lost.
Screenshot 1
Start operation after the submenu of the event menu is
displayed by clicking the [Event] button in the setup
menu (Advanced). (page 15)
Screenshot 2
The window for selection of the event channel/number
will be displayed.
Step 1
Click the respective [SETUP] button for the desired
event (VMD, video loss, terminal/command alarm) to be
set.
Step 2
Click the respective [SETUP] button for the desired
channel/number to be set from the event selected at
Step 1.
55