Panasonic WJ-HD309A Network Set Instructions page 26

The following are available for "Time" (recording dura-
tion).
1 s - 10 s (in 1 second intervals)/20 s/30 s/
1 min - 10 - min (in 1 minute intervals)/20 min/
30 min/40 min/ 50 min/ 60 min
MANUAL: Recording duration differs depending on the
event type as follows;
When motion is detected: Recording will be per-
formed for 8 seconds
When video loss has occurred: Recording will be
performed while the video signal is lost.
When a terminal alarm has occurred: Recording
will be performed during the alarm signal is being
supplied.
When a command alarm has occurred: Recording
will be performed for 8 seconds.
CONTINUE: Record until the ALARM RESET button is
pressed
When "MANUAL" is selected for "Time" (recording dura-
tion), recording will be performed for at least 8 seconds
at an event occurrence as long as the alarm is not can-
celed.
The following are available for "Operation Mode" (event
action mode). Refer to the Network Operating
Instructions (PDF) for further information about each
event action mode.
ACT DET (Activity Detection Mode): Performs only
recording and writing an event log at an event occur-
rence. Other event actions will not be performed.
ALARM (Alarm Mode): Performs recording, writing an
event log, supplying the alarm output and sounding
the buzzer according to the settings for "Event
Setup".
OFF: Performs only recording of the event log. Other
event actions will not be performed.
26
I Event Setup
Perform the settings for the alarm output duration and
the buzzer sound duration for each event type (motion
detection, video loss, command alarm and terminal
alarm).
The following window will be displayed when the
[SETUP] button is clicked. Perform the settings for each
item.
Click the [SET] button after completing the settings, and
close the window by clicking the [×] button at the top
right of the window.
The following are available for "Alarm Output" (alarm
output duration).
When OFF is selected, the alarm output will not be sup-
plied.
(s: second)
OFF: No alarm output is supplied.
1 s - 30 s (in 1 second intervals)/40 s/50 s/1 min/
2 min/3 min/4 min/5 min
EXT: Alarm output will continue until the ALARM
RESET button is pressed.
The following are available for "Buzzer" (buzzer sound
duration).
When OFF is selected, a buzzer will not sound.
(s: second)
OFF: The buzzer will not sound.
1 s - 30 s (in 1 second intervals)/40 s/50 s/1 min/
2 min/3 min/4 min/5 min
EXT: The buzzer will continue until the ALARM RESET
button is pressed.