Planet ICA-4150 User Manual page 42

over the Internet. Therefore, these ports need to be made accessible over the Internet. This is
accomplished using the Virtual Server function on the router. The Virtual Server ports used by
the camera must be opened through the router for remote access to your camera.
Follow these steps to configure your router's Virtual Server settings:
Click Enabled.
Enter a unique name for each entry.
Select Both under Protocol Type (TCP and UDP)
Enter your camera's local IP address (e.g., 192.168.0.100) in the Private IP field.
If you are using the default camera port settings, enter 80 into the Public and
Private Port section, click Add.
A check mark appearing before the entry name will indicate that the ports are enabled.
Some ISPs block access to port 80. Be sure to check with your ISP so that
you can open the appropriate ports accordingly. If your ISP does not pass
traffic on port 80, you will need to change the port the camera uses from 80
to something else, such as 8080. Not all routers are the same, so refer to
your user manual for specific instructions on how to open ports.
Enter valid ports in the Virtual Server section of your router. Please make sure to check the
box on this line to enable settings. Then the device can be accessed from WAN by the router's
WAN IP address.
By now, you have finished your entire PC configuration for this device.
720P IR Dome PoE IP Camera
- 42 -
ICA-4150