Cold Starting - Ezgo 622021-FI Owner's Manual

OPERATING PROCEDURES
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
Check the oil level per the Periodic Service Schedule. Add oil if the level on the dipstick indicates that oil is in the add
oil range.
4
Do not overfill engine. Too much oil may cause smoking or allow oil to enter the air filter enclosure.
The oil dipstick/fill cap must be in place before operating the engine. Failure to install the dipstick/fill cap will result in oil
becoming contaminated and/or being discharged into the engine compartment.
Oil dipsticks are unique to this model vehicle. Do not interchange oil dipsticks between models.
The oil should be changed in accordance with the Periodic Service Schedule while the engine is warm. See SER-
VICE AND MAINTENANCE for checking oil level and changing oil procedures.

COLD STARTING

Starting a cold engine may require use of the choke. Depress the accelerator approximately 1" (2.5 cm) or until the
starter just begins to operate. Pull the choke out if required. Accelerate slowly and push the choke in completely
when the engine runs smoothly.
Do not allow the starter to operate continuously for more than 10 seconds. Allow 30 seconds between starting
attempts. If the vehicle does not start on the third attempt, turn the key switch off, set the park brake and deter-
mine the cause of the problem.
If the vehicle had been running and the engine does not start within 10 seconds, use the choke.
4 - 6
Maximum Oil Level
Fill Cold Engine
For Hot Engine
To This Point
Do Not Overfill
Add Oil
Safe
Operating Range
Hot Engine
Check Oil Level on DipStick
Clean Entire Dipstick