Advertisement
19
Lift Conopy allowing the 2 studs to
protrude through the canopy.
Next lift the cover ring and install
knurled nuts as shown. Tighten the
knurled nuts securely. The canopy
should adjust for any irregularity in
the ceiling or outlet box.
21
Pass lead wires and safety cable
through canopy and then Place
the canopy over the yoke screws
aligning the large holes from the
canopy over the remaining screws
of the yoke.
24
H a n g f a n f r o m m o u n t i n g
bracket by the hands free
hook into a closed hole on
the edge of the Canopy.
27
Install remote receiver into the
mounting bracket.
Go to step 31 to finish
installation
22
Re-stall the 3 screws removed in
step 20.
Safety cable installation
25
Hand free
hook
Safety cable
Lag screw
Lag screw
Safety cable
Washer
Lock washer
For Canadian installation and for USA fan and light
kit combinations over 35 lbs, in both flush and
downrod mode the safety cable must be installed
into the house structure beams using the 3" lag
screws,washers, and lock washers. provided. Make
sure that when the safety cable is fully extended the
leadwires are longer than the cable and no stress is
placed on the leadwires.
28
Supply
circuit
Make wiring connections as indicated above.
White from fan to white from remote marked
N. Blue from fan to blue from remote marked
light. Black from fan to Black from remote
marked L. White from house to white from
remote marked AC N . Black from house to
Black from remote marked AC L. Connect all
green ground wires to Grounded wire from
House.
20
Flushmount Installation
Remove side covers from canopy
Remove set screws and pins from
yoke as shown in inset.
Remove every other screws from yoke
on top of motor housing as shown.
Save screws for later use.
23
Partially install 2 of the screws (screws
provided) to the side panel of mounting
bracket corresponding to the open
slotted holes on the canopy upper rim.
Remove the studs from the lower part of
the mounting bracket.
26
Remote transmitter dip switch
Remote receiver dip switch
Set dip switches on the Remote Transmitter
and Remote Receiver to the same settings.
T h i s m u s t b e d o n e s o t h e u n i t s w i l l
communicate properly. If you have other fans
you can set to control from one transmitter
by setting both receivers the same as the
transmitter. If you have more than one fan
with remote. You can set the dip switches to
different positions to have separate control.
29
Make wire connections to power source using
wire nuts provided. Make sure that no filaments
are outside of the wire nut. After making the wire
connections, the wires should be spread apart
with the grounded conductor and the equipment-
grounding conductor on one side of the outlet
box and ungrounded conductor on the other side
of the outlet box. The splices after being made
should be turned upward and pushed carefully up
into the outlet box.
Advertisement
