Table of Contents
Advertisement
Quick Links
Owner's Guide and Installation Manual
Attach sales receipt to this card and retain as your proof of purchase
DATE OF PURCHASE:
MODEL NUMBER:
To register your fixture, please visit our website www.montecarlofans.com
3MGMR52XXX Series Fan
CUL Model NO. : 3MGMR52
RETAILER NAME:
RETAILER ADDRESS:
6.35 kg
14 lbs
Total fan weight
Advertisement
Table of Contents
Related Manuals for Monte Carlo Fan Company 3MGMR52 Series
Summary of Contents for Monte Carlo Fan Company 3MGMR52 Series
- Page 1 Owner’s Guide and Installation Manual 3MGMR52XXX Series Fan CUL Model NO. : 3MGMR52 Attach sales receipt to this card and retain as your proof of purchase DATE OF PURCHASE: RETAILER NAME: RETAILER ADDRESS: MODEL NUMBER: To register your fixture, please visit our website www.montecarlofans.com 6.35 kg 14 lbs Total fan weight...
-
Page 2: Cautions And Warnings
Cautions and Warnings WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING READ AND SAVE THESE INSTRUCTIONS Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes and standards (ANSI/NFPA 70), including fire-rated construction. -
Page 3: Safety Cable Installation
Ceiling joist Ceiling Outlet Box Ceiling Mounting Joists Bracket Screw/ Washers /Spring Washers 4˝ x 6˝ Outlet Before you begin installing the fan, Switch The outlet box is to be recessed and Use metal outlet box suitable for fan power off at Service panel and lock mounted to the “six-inch”... - Page 4 Downrod Downrod Keeper Cross Yoke Canopy Canopy ring Yoke Cover Following last installation step, engage Partially loosen downrod set screws from Place downrod over canopy, canopy ring blades each other as shown in illustration yoke at top of motor assembly. and yoke cover.
- Page 5 Setscrew Grounding Mounting bracket wire Attach Safety Cable to Ceiling Support Cable Safety cable from fan Slot Set screw Safety cable Hanger ball Cable clamp Thread lead wires, grounding wire and Install ball end of downrod into mounting Connect the safety cable from fan to the safety cable through watertight rubber bracket opening.
- Page 6 Hump Canopy ring Groove Decorative cap Partially loosen 2 of the set screws on Install a blade supporting plate. Install a decorative cap onto motor shaft by turning clockwise until tight. mounting bracket corresponding to the slotted Aligning the holes on blade, blade supporting holes on the canopy upper ring.
-
Page 7: Remote Control Setting And Operation
REMOTE CONTROL SETTING and OPERATION Remove the battery cover from the remote control transmitter and Remote Transmitter install battery. Replace the cover. Note: Use 2 1.5V/AAA battery to replace battery. (Fig. 1) Note: If not using for long periods of time, remove battery to prevent damage to remote transmitter, and store the remote transmitter away from excess heat or humidity. -
Page 8: Light On/Off
LED Indicator The buttons on the remote control transmitter control the fan speed and light as follows. (Fig. 4) UP Speed Press the button to get desired fan speed, Low to High. Down Speed Press the button to get desired fan speed, High to Low. Press the OFF button to turn fan off. -
Page 9: Troubleshooting
Troubleshooting or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, installation, please call our Customer Service Center at the number printed on your parts list insert sheet. Warning and lock the service panel to prevent the power from being switched back on accidentally. If the service panel cannot be locked to prevent the power from being switched on accidentally, securely fasten a warning sign to the service panel. - Page 10 Nov.2022...
Need help?
Do you have a question about the 3MGMR52 Series and is the answer not in the manual?
Questions and answers