Memory Device Base Size; Monitor Line Length; Dip Switch Sw2 Settings - Zenith Z-100 Reference Manual

Memory Device Base Size

Sections 2 and 3 of SW1 indicate the base memory device size. 64K is the only
presently acceptable option. Sections 2 and 3 are both positioned to the left; any
other combinations are reserved.

Monitor Line Length

Sections 4 and 5 of SW1 define the monitor line length, in characters, when the
computer is turned on. Position these sections to the desired configuration for
either 40- or 80-character line length.
Number of Floppy Drives
Sections 6 and 7 indicate the number of floppy disk drives present in the system.
Set these sections to the positions which reflect your floppy drive complement.
Refer to Figure 4.3 for a typical DIP switch SW2 setup. Table 4.2 defines the
options obtainable with the SW2 settings.
TOP
OF CARD
LEFT RIGHT
BOTTOM
OF CARD
0 1 2 3
4 5
REFRESH FREQUENCY SETTING
6 7
DIP SWITCH 2
Figure 4.3. DIP Switch SW2 Settings
Central Processing Unit
RAM ME M O R Y SIZE
AUTO BOOT
Page 4.5