Options - Toshiba e-STUDIO 207L Quick Start Manual

Chapter 6 INFORMATION ABOUT EQUIPMENT

Options

The following options are sold separately, and upgrade the performance of the equipment if installed. For details,
contact your service technician or representative.
For e-STUDIO207L/257/307/357/457/507
For e-STUDIO207L/257/307
For e-STUDIO357/457/507
1.
Original Cover (KA-1640PC)
This is used to hold an original.
2.
Reversing Automatic Document Feeder
(MR-3028)
This unit automatically feeds a stack of originals one by
one to have them copied.
3.
Bridge Unit (KN-2520N)
This unit acts as a relay for the Finisher and this equipment.
4.
Job Separator (MJ-5004N/MJ-5006)
Enables Faxes, copies and prints to be output onto
separate paper trays.
Install the MJ-5004N in the e-STUDIO207L/257/307, and
the MJ-5006 in the e-STUDIO357/457/507.
5.
Offset Tray (MJ-5005)
Enables copied and printed sets to be collated or stacked
in groups with each set being offset.
6.
Paper Feed Pedestal (KD-1025)
This pedestal enables you to install the Additional Drawer
Module (optional, MY-1033).
7.
Large Capacity Feeder (KD-1026)
This feeder enables you to feed up to 2000 sheets (80 g/m
or 20 lb. Bond) of A4 or LT paper.
72
9 10
11 13 12
14
15
6
8.
Additional Drawer Module (MY-1033)
This drawer can be added to the Paper Feed Pedestal
(optional, KD-1025). Combined with the 2 drawers in the
equipment, paper can be fed from 4 drawers in total.
9.
Finisher (MJ-1107)
This Finisher enables sort/group finishing and stapling.
The Hole Punch Unit (optional, MJ-6104E) can be installed
in this Finisher. The Bridge Unit (KN-2520N) is required for
the installation of this Finisher.
10.
Saddle Stitch Finisher (MJ-1108)
This Finisher enables saddle stitching, in addition to sort/
group finishing and stapling. The Hole Punch Unit
(MJ-6104E) can be installed in this Finisher. The Bridge
Unit (KN-2520N) is required for the installation of this
Finisher.
11.
Saddle Stitch Finisher (MJ-1033)
This Finisher enables saddle stitching, in addition to sort/
group finishing and stapling. The Hole Punch Unit
(MJ-6008) can be installed in this Finisher. The Bridge Unit
(KN-2520N) is required for the installation of this Finisher.
When installing in e-STUDIO507: The output speed is
equivalent to the one for e-STUDIO457.
2
1 2
3
4
5
7 8