Programming; To Add Or Reprogram A Hand-Held Remote Control; To Erase All Codes; 3-Button Remotes - Chamberlain HD200CD Security+ Owner's Manual

PROGRAMMING

NOTICE: If this Security✚
in the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
transmitter to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security✚
USING THE "LEARN" BUTTON
1. Press and release the "learn"
button on the motor unit. The
learn indicator light will glow
steadily for 30 seconds.
2. Within 30 seconds, press and
hold the button on the hand-
held remote* that you wish to
operate your garage door.
3. Release the button when the
motor unit lights blink. It has
learned the code. If light bulbs
are not installed, two clicks will
be heard.
® garage door opener is operated with a non-rolling code transmitter, the technical measure

To Add or Reprogram a Hand-held Remote Control

To Erase All Codes From
Motor Unit Memory
To deactivate any unwanted remote, fi rst erase all
codes:
Press and hold the "learn" button on
motor unit until the learn indicator light
goes out (approximately 6 seconds).
All previous codes are now erased.
Reprogram each remote or keyless
entry you wish to use.
*3-Button Remotes (315 MHZ)
If provided with your
garage door opener,
the large button is
factory programmed
to operate it.
Additional buttons
®
on any Security✚
3-Button remote or
compact remote can be programmed to operate other
Security✚ ® garage door openers.
35
remote controls.
®