GMC Yukon 2007 Owner's Manual page 525

After the tires have been rotated, adjust the front
and rear inflation pressures as shown on the
tire and loading information label. See Loading
Your Vehicle on page 411 and Inflation - Tire
Pressure on page 518, for more information.
Vehicles that have the Tire Pressure Monitor
System (TPMS) will need to have the TPMS
sensors reset after a tire rotation. See "TPMS
Sensor Identification Codes" under Tire Pressure
Monitor System on page 519.
Make certain that all wheel nuts are properly
tightened. See "Wheel Nut Torque" under
Capacities and Specifications on page 573.
CAUTION:
{
Rust or dirt on a wheel, or on the parts to
which it is fastened, can make wheel nuts
become loose after time. The wheel could
come off and cause an accident. When
you change a wheel, remove any rust or
dirt from places where the wheel attaches
to the vehicle. In an emergency, you can
use a cloth or a paper towel to do this;
but be sure to use a scraper or wire brush
later, if needed, to get all the rust or dirt
off. See Changing a Flat Tire on page 534.
525