Table of Contents
Advertisement
PC104-PLUS1500
1
DEFINITION OF APPLICATION
1.1
Intended use
The board PC104-PLUS1500 must be inserted in a PC/104-Plus system with PCI
slot, which is used as electrical equipment for measurement, control and
laboratory pursuant to the norm IEC 61010-1.
1.2
Usage restrictions
The PC104-PLUS1500 board must not to be used as safety related part for
securing emergency stop functions.
The PC104-PLUS1500 board must not be used in potentially explosive
atmospheres.
1.3
General description of the board
Data exchange between digital data between the board PC104-PLUS1500 and the
peripheral is to occur through a shielded cable. This cable must be connected to
the 37-pin SUB-D male connector.
The board has 16 input channels and 16 output channels 16 output channels for
processing digital signals.
The use of the board PC104-PLUS1500 in combination with external screw
terminal panels is to occur in a closed switch cabinet.
The screw terminal panel PX901-DG allows the connection of digital signals to
the peripheral through the cable ST010.
The connection with our standard cable ST010 complies with the following
specifications:
metallized plastic hoods
-
shielded cable
-
cable shield folded back and firmly screwed to the connector housing.
-
The use of the board in a PC/104 system could change the features of the system
regarding noise emission and immunity. Increased noise emission or decreased
noise immunity could result in the system not being conform anymore.
Check the shielding capacity of the system housing and of the cable prior to
putting the device into operation.
The use of the board according to its intended purpose includes observing all
advises given in this manual and in the safety leaflet.
Uses beyond these specifications are not allowed. The manufacturer is not liable
for any damages which would result from the non-observance of this clause.
Make sure that the board remains in its protective blister pack until it is used.
Definition of Application
7
Advertisement
Table of Contents
