Installation of the board
i
5.2.1 Switch off the housing/system and all units connected to
the housing/system
♦ Pull the housing/system mains plug from the socket
♦ Open the housing/system as described in the manual of the manufacturer
♦ Follow the instructions of the manufacturer
5.2.2 Fastening the board
♦ Select an adequate slot
♦ Plug the board onto the respecting slot
1
In the picture a SIMATIC Microbox PC 420 was used
18
IMPORTANT!
You must observe the safety instructions, in the present manual,
in the yellow leaflet (safety precautions) and the instructions of
your housing/system manufacturer.
Fig. 5-2: Connector with PCI-/ISA signals
PC104-PLUS1500
1
1 F