Installation Of The Board; First Steps; Board Insertion Into A Housing/System; Fig. 5-1: Setting The Turn Switch - Addi-Data PC104-PLUS1500 Technical Description

PC104-PLUS1500
5

INSTALLATION OF THE BOARD

5.1

First steps

Before beginning with the installation of the board, please ensure that the turn
switch (see F ig. 5-1) is set correctly. Set the turn switch in the way that it matches
1 0 4 H
the position of the board PC104-PLUS1500 on the CPU (see
Position of the PC104-PLUS1500 on the
PC104-PLUS1500 is the 1. board on CPU
PC104-PLUS1500 is the 2. board on CU
PC104-PLUS1500 is the 3. board on CPU
PC104-PLUS1500 is the 4. board on CPU
♦ Check if the turn switch is set correctly (see table above)
If the setting is correct, you can continue with the installation (see
♦ Set the turn switch to the correct position with a screw driver
5.2

Board insertion into a housing/system

The following sections describe the board insertion into the housing/system of any
manufacturer. Therefore, the following part is only a general overview as it does
not consider the differences when inserting it into the housings/systems of other
manufacturers. Thus, please do observe also the instruction of your
system/housing manufacturer. Should you have any questions, please contact us.

Table 5-1: Position of the turn switch

CPU

Fig. 5-1: Setting the turn switch

Installation of the board
T able 5-1)
1 0 5 H
Position of the turn switch
0 (alternatively 4*)
1 (alternatively 5)
2 (alternatively 6)
3 (alternatively 7)
* State of delivery
F ig. 5-1):
1 0 6 H
17